Inqontrol Frequency Master 10 Amp.

The Frequency Master is suitable for one or two fans and it has a 5 meter long temperature sensor (NTC) and a 5 meter long light sensor. With three simple dails you can set the minimum speed, the maximum speed and the desired temperature. The software wil then determine the needed speed to keep the temperature at the set point.

The Frequency Master ensures an absolut silent and buzz or humm free running of the connected fan(s). It is the most optimale way to controle an AC motor. The on-board temperature control software provides faster reaction times, lower idling speeds and improved accuracy for the very best result from this type of controller.

Humidity can rise sharply during the night. To keep this humidity within acceptable values, you can choose to use the night-mode. The Frequency Master switches up twice an hour for a few minutes in small steps to a maximum speed of 80%. Thereby lowering the moisture in the air.

To use the Night-Mode simple remove the rubber cap from the light sensor the Frequency Master will now operate in night/ day mode. The green LED will now light up. Indicating the Frequency Master is in night mode.

If you want to switch the night mode off, unplug the Frequency Master. Place the rubber cap over the lightsensor, wait 5 seconds and then plug the Frequency Master back in. The night mode is now switched off. The green LED is now switched off.

Note: Too slowly rotating fans can caus failure of the fans. So make sure that the minimum level is not set too low.

Suitable for one or two fans;

Software-controlled;

Frequency controller technology;

Absolutely silent;

Temperature sensor with a 5 meter long cable (NTC);

Light sensor with a 5 meter long cable (LDR);

Automatic climate regulation;

Night-mode for dehumidification during the night cycle;

Extra safe thanks to an additional fuse (spare fuse supplied).